I also don't have wired access working at all.iwconfig shows connected to correct ESSIDI can ping localhostcan't ping google:Code:ping: unknown host www.google.comcan't ping my router (192.168.2.1):[code].... static is dead, just dead. I have the exact same net-auto-wireless config file that I have on my other machines, so I'm sure it's not a problem with the configuration. May 22 23:24:34 hostname kernel: [ 1563.119807] /dev/vmnet: open called by PID 1671 (vmnet-bridge) May 22 23:24:34 hostname kernel: [ 1563.119836] /dev/vmnet: hub 0 does not exist, allocating memory. Source
asked 2 years ago viewed 713 times active 2 years ago Related 3Configure Atheros AR9285 wireless in Gentoo3Activating WiFi in Fedora5802.3ad on FreeBSD and Linux using crossover cables?3debian wireless networking through Everyone could access the internet again. Can you ping outside IP addresses like 126.96.36.199? Now it does sound like the router is forwarding directly to my laptop, instead of allocating internal ips. https://ubuntuforums.org/showthread.php?t=1984317
Cannot Ping Gateway
Networking :: 3 NIC - Router - PC Cannot See My Laptop And Vice Versa - Cannot Ping - Host Seems Down Networking :: Cannot Ping Gateway Or Access Router Administrator Your DNS resolution is not working properly. View 9 Replies View Related Ubuntu Networking :: D Link ADSL Router - Ping: Sendmsg: Operation Not Permitted Jan 13, 2010 I use a wired Dlink Adsl Router GLB502T with its Why is that IP address a problem? –frontrow Oct 30 '15 at 19:50 As I mentioned early, check the router and smart switch profile to solve your problem. –Shameerariff
Introduction to Linux - A Hands on Guide This guide was created as an overview of the Linux Operating System, geared toward new users as an exploration tour and getting started
I have observed several people having issues with this configuration and I have tried some resolutions, without success.
I have tried several IP addresses and 100% success rate.
Sep 14, 2010 So I installed 10.4 on a new Toshiba Satellite L645DWhen I connect to my wireless at home, the Network Manager shows that I am connected but I can't
Sep 20, 2010 I have a desktop computer (Ubuntu) connected to one of the LAN ports of the Cradlepoint MBR1000 router via an Ethernet cable.
Below is my output to ifconfig: Output of ifconfig: eth0 Link encap:Ethernet HWaddr 00:26:b9:e2:3d:20 UP BROADCAST MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
This means that when you connect to a network, your computer is given an IP address within a range specified by a DHCP server.
You can check if you're associated to a router by running the command sudo iwconfig.
I've looked into host.conf, networks, interfaces, hosts and resolv.conf and either my settings are wrong or it's something else.
Can a president win the electoral college and lose the popular vote I am seen in darkness and in light, What am I? This is what Roadrunner says to do any time connectivity is lost. Add a route between your router and wireless adapter. Is it possible for a diesel engine computer to detect (and prevent) a runaway condition?
Cannot Ping Default Gateway Windows 7
Sure, it might be configured only for Windows (is that even possible?), but I cannot change it, and he doesn't have time to call and get it changed. http://softwaredevelopercertification.com/cannot-ping/ubuntu-server-cannot-ping-router.php Information on host AP; hostapd; wpa_supplicant Using ndiswrapper with WPA - The Ubuntu Wiki Guide to using ndiswrapper with WPA wireless encryption. Behavior of other machines: Can ping router and router can ping them. share|improve this answer edited Feb 13 '14 at 18:12 slm♦ 168k42311483 answered Feb 13 '14 at 16:52 Keiran Holloway 20114 I've formatted it in the question and I've tried
then well, you're going to still have problems. What's going on?.Do I have to change some settings in router?. You will need to make sure your /etc/network/interfaces file is set up properly so you get internet again when you reboot 4. have a peek here I found this a good read for that.
Check that the connection allows you to browse the internet.
One to the ADSL router and another to the local hub. I also tried Ubuntu 9.10 from the live CD and it also reported a connection, IP address, etc. Anyway, he doesn't know about getting into the router's GUI, and not ever having this ISP, I'm guessing that Verizon doesn't want customers changing those settings. So traffic WAS getting through - so much so that doing pacman -Sy actually worked, although it was very slow.
But if I gave ping -I eth1 then I can ping.I cannot install any package, so tell me solution which includes not installing any package. I have port 53 open. Offline #3 2012-01-10 22:08:33 Hiram Member From: Brisbane, Australia Registered: 2010-02-13 Posts: 67 Website Re: Wireless connects and I get an IP, but I can't ping anything As I said in Check This Out Thanks heaps.